Bullet Frame Slider Set RACE version in alluminium tubular and nylon 6.6

GBRacing products are clearly the bench mark performance, bolt on Motorcycle Protection for the Short Circuit, Road Racing and Street Bike community. Testament to this is the fact that we are the only Company to have received FIM product approval for 2010-2012. This has now been renewed for 2013 through to 2016 on our range of Bolt on Secondary Engine Covers, along with MCRCB, FFM, IDM, AMA, CIV, IDM, FFM, & World Endurance approval.
 

NOTE: The models from 2012 onwards requires modification to the right hand side fairing to fit correctly.
 

Each product is specifically designed, engineered and manufactured to deliver the best overall quality protection. Our core product range is our FIM approved Bolt on Secondary Engine Covers. We vary the injection moulded material thickness, from 2mm to 12mm, providing both maximum protection, with sufficient ground clearance, and weight saving too. Our Crash Bobbins, Frame Sliders and Bullet Sliders are engineered with the same exacting level of care and attention to detail. They dissipate force in their structure and are designed to bend under heavy forces rather than transfer these potential forces to the bike. They greatly reduce the possibility of ‘flipping the bike’, potentially causing more damage. Our Bullet Sliders are manufactured in 2 versions. The Race version, sitting underneath or parallel with the fairing, concentrating on protecting the frame, radiator and other areas. The Street version protrudes beyond the fairing, where fairing damage is a high priority. Both providing another point of contact in the event of a crash.

Our GBRacing Alternator crank covers are designed to provide the best protection to your motorcycles alternator. We have designed these alternator crank covers to fit the standard stock casings and the modified kit alternators. The alternator is located on the left hand side of your motorcycle. All of our covers come supplied with replacement bolts. No need to remove stock casings or gasket seals. What is the difference between STOCK and KIT Engine Covers? The STOCK refers to the stock casings, as you would see on your bike in the Showroom. The KIT refers to factory casings, normally the alternator cover, where race teams would purchase factory alternators that produce minimal recharging of the battery, and increase in BHP. Therefore, the KIT alternator cover is designed for a KIT alternator casing which has replaced the standard manufactured casing.

The GBRacing clutch cover will provide protection and style to your motorcycles clutch. This clutch cover is fitted over the existing clutch on the right hand side of your motorcycle. All of our covers come supplied with replacement bolts for your clutch crank cover. No need to remove stock casings or gasket seals.

The timing crank cover is located on the right hand side of your motorcycle. The timing cover is usually the smallest of the set. Once again, all of our covers come supplied with replacement bolts. We highly recommend using the timing crank cover with our clutch crank cover for maximum protection. No need to remove stock casings or gasket seals.

Our revolutionary bullet sliders have been developed and tested for their strength, effectiveness and durability on Race bikes in the British Superbike and Supersport Championship with excellent results. These bullet sliders can also have the moulded tops removed and replaced after a crash creating a very cost effective product.

The STREET refers to the street bullet sliders. These street bullet sliders will extrude from your fairings. They will not only provide protection to your fairings. The RACE refers to the RACE developed bullet sliders. These sliders are designed to fit flush to, or under, your motorcycle fairing. They are designed to protect your radiator, frame and other vulnerable areas.

Using our tough 6.6 long glass nylon we have produced a strong, durable lower chain guard to help protect your hands and legs. This chain guard will also stop your fingers or feet from getting caught in the chain during a crash.

Purchase our GBRacing bobbins to really complete your protection bundle. These bobbins will help to minimise damage to your swing arm during a crash. They also double up as paddock stand mounting points.

This protects your front forks and disks.